Operation Method - Makita PM7651H Original Instruction Manual

OPERATION METHOD

Installing the strainer
The mist blower is provided with the strainers at the solution tank opening and the
pipe inlet head.
Always make sure the strainer is installed in place.
To install the strainer, push it in place.
To remove the strainer, pry it out of place.
WARNING:
Tighten the tank cap firmly. Failure to tighten the tank cap may cause solution
●
leakage, pressure reduction and the like.
Adjusting the shoulder strap
Adjust the shoulder strap to a length that is comfortable to work while carrying the
mist blower.
Adjust as shown in the figure.
To tighten strap
Hip belt (optional accessory)
The hip belt (optional accessory) enables the operator to carry the appliance more
stably.
Adjusting the control handle
Move the control handle along the swivel pipe to the most comfortable position.
Filling the solution tank
1. Keep the gasket (1) in good condition and lubricated with grease and clean.
2. Put the mist blower on a flat surface.
To loosen strap
17
(1)