oventrop OVSOL System 5 Manual page 21

Adjustable Roof Mounting Rack FLUSH MOUNTING
Assemble Collector Rails
Attach hinge leafs to the collector rails (stainless steel) as shown in figures 3 and 4. Leaf C mounted on the upper part of the
collector rail is bolted through holes 9 and 10, with the barrel side pointed to the end. On that same end, using square nuts,
bolt the manifold supports to holes 1 and 3. At the other end of the collector rail, bolt the hinge leaf C to holes 1 and 2, with
the barrel out beyond the rail. Do not tighten the bolt in hole 2. The hinge leaf barrels on each rail must be 75 inches apart,
as shown in drawing below.
Mount Collector
Attach collector feet to the mounting surface, parallel to each other, at the appropriate dimensions. Dimensions are avail-
able in Table 1.
Attach the collector rail hinge leafs C to the mounted front and rear foot for each rail (figure 3).
Center and bolt the bottom tube support in hole 2 of the collector rails. You must removed the loose bolt in order to do this.
Slide the header box into the mounting brackets on the top of the collector. Insert a tube at either end and check for parallel
lines.
Insert remaining tubes
Bottom Tube Support
Foot
5/16" Bolts
Leaf C
75"
Manifold
1" Spacer
FIGURE 4
19