Table of Contents
Advertisement
c.
To install a full-length expansion card, hold the card just above the expansion socket on the
system board then move the card toward the rear of the chassis (1) so that the bottom of the
bracket on the card slides into the small slot on the chassis. Press the card straight down into the
expansion socket on the system board (2).
d.
Rotate the drive cage down (see
e.
Connect the power and data cables to the rear of the drives in the drive cage.
10.
Rotate the slot cover retention latch back in place to secure the expansion card.
11.
Connect external cables to the installed card, if needed. Connect internal cables to the system board, if
needed.
12.
Reassemble and reconfigure the computer, if necessary.
52
Chapter 4 Removal and replacement procedures
Drive cage on page
29)
Advertisement
Table of Contents
