Table of Contents
Advertisement
Switching off the alarm:
•
to acknowledge and switch off the acoustic alarm, press the I key. When the I key is pressed the
first time, the alarm will be switched off and the highest temperature registered in the relevant
compartment will be indicated on the B or C display unit. When the I key is pressed the second
time, the currently set temperature will flash on the B or C display unit. The temperature indication
will continue to flash until the actual temperature in the appliance drops below the alarm level.
•
When the appliance reaches an adequate temperature, then the temperature display will stop
flashing and it will be lit continuously.
•
If you do not acknowledge and switch off the acoustic alarm, then it will be activated every hour
for approximately 15 minutes.
Open door alarm
If the refrigerator or freezer compartment door is open for too long, an acoustic alarm (repetitive beep)
will be activated. If the alarm is not switched off manually, it will be sounded for 10 minutes. The
appliance will continue to operate as if the door was closed.
To switch off the alarm: to switch off the alarm, close the appliance door.
INFORMATION!
If you switch off the alarm by pressing the I key, it will be activated again after 4 minutes if the
door is still open.
INFORMATION!
If you leave the door open for more than 10 minutes, the alarm will no longer be sounded.
Appliance operation will switch to safe mode in order to provide sufficient cooling and prevent
food spoilage despite the open door.
Power outage/power supply failure alarm
When you press the I key again, the power outage (power supply failure) alarm will be finally deactivated
and the set temperature will appear on the B or C display unit.
If the high temperature alarm is activated at the same time, it will operate as described in the chapter
High temperature alarm, after you have deactivated the power supply failure alarm.
If the temperature in the appliance increased to alarm level during a
power outage (power supply failure), then the high temperature alarm
will be activated when power supply is restored. Acoustic alarm will be
activated, and PF will flash on the B or C display unit, depending on the
appliance compartment in which the temperature is too high.
To acknowledge and switch off the alarm, press the I key. The highest
registered temperature will be indicated on the B or C display unit.
25
Advertisement
Table of Contents
