Craftsman 320.2819 Product Manual page 32

To adjust Depth with the Depth-Adjustment Wrenc_ (Fig° 21)
NOTE: The Depth-Adjustment Fig° 2i
Wrench supplied is used to
adjust the depth of cut when
the router fixed to the router
table (Model No. 320. 28180).
The bit depth can be adjusted
by turning the Micro Adjust-
ment Dial clockwise or coun-
terclockwise with the wrench
supplied. The depth of the
cut can be read on the scale
dial. Each mark on the scale
indicates a 1/64 in. change in
depth setting°
1. Switch off the router°
2. Loosen the router motor clamp°
3o Insert the wrench into the adjusting hole on the tabl_e top, turn the adjustment
knob clockwise with the wrench to move the collet ]down, or counterclock-
wise to move the collet up,,
4. When the desired depth of cut is set, tighten the cl_mpincl lever.
28190 ManuaLRevised 07-0409 Page 32