Advertisement
The device is designed to attract and kill mosquitoes and other flight insects. The insects are attracted by the UV-light and then electrocuted by the high voltage grid. Any other use as the mentioned is not permitted! No liabilities will be taken for damages or consequential damages or claims resulting out of not reading and/or not following the user guide and/or any form of modification on or in the product. Under these circumstances, no warranty services will be granted.
Mosquitoes are nocturnal insects; they come out at dusk and are always attracted by light. But they are also attracted by the smell and breath of humans. You should therefore try catching them before you use the room in question. For a higher success rate you should consider the following points:
Note: the response of each insect to our insect killer may vary. The development of our devices, methods and application tips are based on experience, testing and feedback from our customers. The function of attracting flying insects only applies to insects that react to light.
Attention! Not suitable for use in barn, stables and similar locations (Fire danger)!
High voltage! The device generates "high voltage" when it is in use. Hang the device by the preinstalled mounting ring so that the device is out of reach. Never use the device, set it up or hang it up so that it is within reach!
Attention! Please observe the country-specific rules on the use of insect killers. Operation out of doors is prohibited in Germany for environmental protection reasons since useful insects could be killed!
Find a suitable location and insert the plug into a mains socket. The Insect Killer is ready for use. You can stand or hang up the flying insect killer. Please note that the Insect Killer and the power cord should always be placed out of the reach of children.
Important warning when drilling in walls:
Before drilling, make sure that there are no gas, water or power lines located at the drilling spot. Installation may only be done by competent persons. Please pay attention to the condition and material of the wall as the included mounting material is not suitable for all wall types. Please ask an expert for advice concerning suitable screws and dowels. For improper mounting and resulting damages the manufacturer assumes no liability.
Cleaning:
Before cleaning the device, disconnect the power plug and wait 30 seconds for the high voltage grid to unload. First clean the grille with the included narrow brush. To empty the drip tray, the screw must first be loosened with a screwdriver. To empty the collecting tray, give the bottom of the unit a short turn. The tray will become loose and can easily be cleaned. You can clean the tray under running water. Make sure the tray is completely dry before replacing it.
Service Hotline: Phone +49 (0) 53 02 9 34 87 88
tevigo GmbH
Raiffeisenstraße 2 D
38159 Vechelde (Germany)
www.gardigo.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the 62331 that isn't answered in the manual? Leave your question here.