Epson TM-m50II-H Quick Start Manual

The following standards are applied only to the products that are so labeled.
(EMC is tested using the Epson power supplies.)
North America: FCC Class A, CAN ICES-3 (A)/NMB-3 (A)
To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding. Equip-
ment (or its transmit antenna) that is installed outdoors is subject to licensing.
Afin de prévenir les interférences radio au service sous licence, cet appareil est
destiné à être utilisé en intérieur et à l'écart des fenêtres afin de fournir un blind-
age maximum.
L'équipement (ou son antenne de transmission) qui est installé à l'extérieur est
soumis à une licence.
WARNING
The connection of a non-shielded interface cable to this device will invalidate the
EMC standards of this device.
AVERTISSEMENT
La connexion d'un câble d'interface non blindé à cet appareil invalidera les normes
CEM de cet appareil.
FCC/IC Compliance Statement
Déclaration de conformité FCC/IC
NOTE: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will
be required to correct the interference at his own expense.
Supplier's Declaration of Conformity
According to 47CFR, Part 2 and 15 for Class A Personal Computers and Peripherals;
and/or CPU Boards and Power Supplies used with Class A Personal Computers:
We: EPSON AMERICA, INC.
Located at: 3131 Katella Ave.
Los Alamitos, CA 90720
Telephone: 562-981-3840
Declare under sole responsibility that the product identified herein, complies
with 47CFR Part 2 and 15 of the FCC rules as a Class A digital device. Each product
marketed, is identical to the representative unit tested and found to be compliant
with the standards. Records maintained continue to reflect the equipment being
produced can be expected to be within the variation accepted, due to quantity
production and testing on a statistical basis as required by 47CFR §2.906 Oper-
ation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Trade Name: EPSON
Type of Product: Thermal Printer
Model: M376C

Countries and regions where this product can be used

This product can be used only in the countries and regions listed below:
Ce produit peut être utilisé uniquement dans les pays et régions suivants:
051/052 model
CA US
Canada United States of America
Availabilities and Restrictions on Wi-Fi® Channels for
The following table shows the availabilities and restrictions for the Wireless LAN connection in each country or region.
1: Available. 2: Available, but outdoor use is prohibited. -: Unavailable.
Le tableau suivant indique les disponibilités et restrictions pour la connexion au réseau local sans fil dans chaque pays ou région.
1: Disponible. 2:Disponible, mais l'utilisation à l'extérieur est interdite. -: Non dipsonible.
CA Canada
US United States of America

Standards and Approvals

2.4GHz
W52
1-11 ch 12, 13 ch 36-48 ch
1 - 2
1 - 1
©Seiko Epson Corporation 2023
Printed in XXXXXX
Imprimé XXXXXX
This device complies with part 15 of FCC Rules and Innovation, Science and Eco-
nomic Development Canada's licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes
des CNR d'Innovation, Sciences et Développement économique Canada applica-
bles aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage subi, même si le brouillage est suscepti-
ble d'en compromettre le fonctionnement.
This equipment complies with FCC/ISED radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules. This
equipment should be installed and operated keeping the radiator at least 20cm
or more away from person's body.
Cet équipement est conforme aux limites d'exposition aux rayonnements énon-
cées pour un environnement non contrôlé et respecte les règles les radioélec-
triques (RF) de la FCC lignes directrices d'exposition et d'exposition aux fréquenc-
es radioélectriques (RF) CNR-102 de l'ISED. Cet équipement doit être installé et
utilisé en gardant une distance de 20 cm ou plus entre le radiateur et le corps
humain.
FCC Compliance Statement for Users in the USA
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Innovation, Science and Economic Development
Canada (ISED) Notices
Avis d'Innovation, Sciences et Développement
économique Canada (ISDE)
The device for operation in the band 5150–5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems;
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés
uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouil-
lage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.
Users should also be advised that high-power radars are allocated as primary
users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that
these radars could cause interference and/or damage to LE-LAN devices.
Les utilisateurs devraient aussi être avisés, d'une part, que les utilisateurs de
radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu'ils ont
la priorité) des bandes de 5 250 à 5 350 MHz et de 5 650 à 5 850 MHz et, d'autre
part, que ces radars pourraient causer du brouillage et/ou des dommages aux
dispositifs de RL-EL.
5 GHz
W53
52 ch 56-64 ch 100-116 ch 120-128 ch 132–140 ch 149–161 ch
1 1 1
1 1 1
W56
- 1 1
- 1 1
W58
165 ch
1
1