Nikon SB-102 Nikonos Instruction Manual page 9

5
Replace the C -type
• battery cartridge in
the battery chamber.
Be sure the speedlight power switch
®
is in the " OFF" position , then
align the groove on the battery car-
tridge with the notch on the inside
of the compartment and slide the
battery cartridge into the chamber.
8
Lock the buckle lockl
• release latches.
Push the buckle lock/release
latches over the edges of the
buckles to lock them .
6.
Replace the battery
chamber cap.
While holding the buckles away
from the battery chamber cap,
align the battery chamber cap
index
@
with the index on the speed-
light case and replace the battery
chamber cap.
Check the O·ring:
Before replacing
the battery chamber cap, examine
its O-ring for dust and scratches
and be sure it is properly seated
and lubricated .
9
Loosen the joint
• knob
®.
To loosen the joint knob, turn it
counterclockwise while holding the
joint plate
®.
7,
lock the buckles.
• Push the battery chamber cap
against the speedlight case so it is
fully seated , hook the silver buckle
catches onto the pins on the speed-
light case , and pull the buckles in-
ward and upward until they lock
into position.
• When locking the buckles, be sure the silver
buckle catches are hooked onto the pins on
the speed/ight case.
10
Properly position the
• joint plate.
Turn the joint knob so the flat sides
of the joint plate are parallel with
the flat edges of the joint.
9