Table of Contents
Advertisement
17
Loosen the arm
• knob @.
Turn the arm knob
counterclock-
wise as far as it will go to loosen it
(the two bracket positioning pins
on the bottom of the grip
@
will
be visible).
19
Attach the cord
• fastening hanger
®
to the bracket.
As shown in the photo, slide the
cord fastening hanger onto the
bracket.
18
Attach the bracket
•
®
to the arm.
Slide the open end of the bracket
between the arm knob and the
grip,
seat the two bracket positioning
pins
in the two indentations on the
bracket
,
and turn the arm knob
clockwise as far as it will go to lock
the bracket into
position.
20
Remove the
• camera's flash sync
socket cover.
Turn the camera 's sync socket
cover counterc lockwise with a coin
to remove it.
•
The
correct
arm/bracket position is
with
the
three washers on the underside
of
the
bracket,
the
rubber
side
of
the bracket facing
up,
and flat side of the grip perpendicular
to the bracket.
21.
Attach the camera
body to the bracket.
With the camera against the rubber
side
of
the
bracket and
the camera 's
tripod socket over the bracket
screw,
screw the bracket screw
into the camera 's tripod socket
until the camera and bracket are
securely
attached.
Nikonos·Vor Nikonos IV·A
11
Advertisement
Table of Contents
