Brother DCP-B7600DB Quick Setup Manual

D02XKD001-00
ASA/GLF
Version 0
EN
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies.
AC Power Cord
1
Remove the packing materials and install the toner cartridge and drum unit assembly
2
Load paper in the paper tray
3
Connect the power cord and turn the machine on
Back
Quick Setup Guide
DCP-B7600DB / DCP-B7620DW / DCP-B7620DWB / DCP-B7640DW / DCP-B7640DWB /
MFC-B7810DW / MFC-B7810DWB / MFC-B7811DW
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
Not all models are available in all countries.
The latest manuals are available at the Brother support website:
support.brother.com/manuals
Drum Unit
Quick Setup Guide Product Safety Guide
Front
NOTE:
• The components included in the box may differ depending on your country.
• The available connection interfaces vary depending on the model.
If you use a wired connection, you must purchase the correct cable for the
interface you want to use.
Toner Cartridge
• The screens and images in this Quick Setup Guide show the MFC-B7810DW.
• Save all packing materials and the box in case you must ship your machine.
1
2
Remove the orange part.
Do not exceed this mark.
Adjust the paper
guides.
• USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
• Network cable (for wired network models only)
Use a straight-through Category 5 (or greater) twisted-pair cable.
1
Push firmly.
4 Select your country/language
(Initial setup only)
After turning the machine on, you may be required
to set your country or language (depending on your
machine).
If required, follow the on-screen instructions.