Hayward VariFlo SP0712 Owner's Manual

VariFlo
GENERAL
1. Proper fitting make-up is hand tight plus one to 1-
1/2 turns maximum. Always use Teflon pipe tape
or Permatex No.2 for connections to provide a
good, "living" seal.
IMPORTANT: Do not over tighten pipe fittings.
2. SERVICING VALVE: If it becomes necessary to
service or gain access to the key or valve seat
gasket:
a. Set handle in "Winterizing" position.
b. Remove cover screws.
c. Lift cover and key assembly out.
3. RE-ASSEMBLY VALVE:
a. Wipe debris from cover 0-ring.
b. Set handle in a "Winterizing" position. Align
flat edge on cover with body. Press down to
seat assembly.
c. Secure assembly to body with cover screws
and nuts. Tighten cover screws evenly and
alternately.
Do not over tighten.
CAUTION –Spring Hazard
pin if servicing key O-ring. Remove handle pin before slowly removing Cover screws in an alternate pattern.
WARNING
-
Failure to follow instructions can cause severe injury and/or death.
®
1 1/2" Filter Control Valve
Owner's Manual
Model: SP0712
TURN OFF PUMP BEFORE CHANGING VALVE POSITION
VALVE
SETTING
WINTERIZING:
– Release of Valve spring compression can cause personal injury. To avoid, only remove handle
Read and follow all instructions
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07207
Phone: (908) 355-7995
WWW.HAYWARD.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Multiport
FUNCTIONS OF VALVE POSITIONS
FLOW DIRECTION THROUGH VALVE
(Sand Filter)
FILTER
For normal filtration and vacuuming pool through filter.
(Sand Filter)
PUMP - BOTTOM - THROUGH FILTER - TOP – WASTE
BACKWASH
For cleaning filter.
PUMP - THROUGH FILTER in filter direction - WASTE
RINSE
For initial start-up and clearing valve of debris after
backwashing.
PUMP – THROUGH VALVE ONLY - WASTE
WASTE
For vacuuming directly to waste, lowering pool level
and/or draining pool.
NO CIRCULATION PAST PUMP PORT
CLOSED
For shutting off all flow to filter and pool.
PUMP – THROUGH VALVE - RETURN
RECIRCULATE
For bypassing filter, but circulating pool water.
Drain and winterize filter and pump per manufacturer's
instructions. To drain water from VariFlo® Multiport
valve—depress and rotate valve handle and place handle
pointer between any detente positions.
REPLACEMENT PARTS
REF
PART NUMBER
NO.
1 SPX0710XF Handle, Standard
2 SPX0710XZ7 Pin, for Handle
3 SPX0710Z16 Non-Metallic Bearing (Pack of 5)
4 SPX0710G Valve Position Label
5 SPX0710Z1A Cover screw set with nuts (Set of 6)
6 SPX0710XZ5 Cover O-ring
7 SPX0735GA O-ring & TFE Shaft seal set
8 SPX0710Z62 Spring Washer Set (Set of 2)
9 SPX0603S Spring
10 SPX0710XC Key/Stem assembly
11 SPX0710XD Valve Seat Gasket
12 SPX0710MA Sight Glass with Gasket
SPX0710BA17 Key, Cover & Handle Assembly
in this owner's manual and on the equipment.
PUMP - TOP - THROUGH FILTER - BOTTOM - RETURN
NO.
DESCRIPTION
REQ'D
1
1
1
1
1
1
1
1
1
1
1
1
IS0712 REV B
1