Nikon N55 Instruction Manual page 21

3 Gently close the camera back until the camera back snaps
closed.
-~
:(,5 F5.6
@
BE
u
3[m
J
2 )
• The film automatically advances to final frame with blinking
0 , 0 _ , 0 __ , 0 ___
as
indicated in LCD panel.
• When the film has completed set up, a shutter sound is let out but no picture has
been taken.
• LCD Panel indicates number of exposures left on film.
• Film rewinds one frame at a time as photos are taken .
• When E appears in the LCD
panel, film is not properly installed. Open the camera
back again and reload film by aligning the film leader to the red index mark.
• When
Err
and E in the LCD panel and
Err
in viewfinder blink, film is not
correctly advanced. Open the camera back again and reload film .
• Pictures taken on frames beyond the indicated number of the exposures for the
film roll may be discarded in the process of developing .
OX-coded film
With OX-coded film , film speed will be set
automatically between ISO 25 to ISO 5000.
Film speed is set to ISO
100
with non-OX-
coded film .
Check points
OX-coded film
~ ISO
(film speed)
~~
j6
I);
DX mark
• Avoid direct sunlight when changing film outdoors.
• You can check the number of available exposures on the film roll and film speed
through the film confirmation window.
• Infrared films cannot be used with this camera since an infrared sensor is used for
the detection of the film frame position.
21