Levelling - Samsung DV7 TA2 Series User Manual

Levelling

Before you install the dryer, make sure you have read Installation requirements on
page 20. Please note that the following instructions are for installation without using
a drain hose. For instructions for using a drain hose, see the next section, Drain hose
(if necessary). For convenience, consider installing the dryer next to your washer.
C
DV5000T_DC68-04209F-02_EN.indd 23
A
B
D
1. Gently slide the dryer into the
desired location.
2. Use a level (A) and check the
levelness of the dryer from side to
side and front to back.
3. If the dryer is not level, adjust the
levelling leg (B). Turning the leg
counter-clockwise retracts the leg.
Turning the leg clockwise extends
the leg.
4. Once the dryer is level, make sure
the dryer stands firmly on the floor.
5. Plug in the dryer.
NOTE
• The dryer can be levelled using
either or both of the front and rear
legs of the dryer.
• To set the dryer to the same height
as the washer, fully retract (C)
the levelling legs by turning them
counter clockwise, then loosen (D)
the legs by turning them clockwise.
• Extend the levelling leg only as
much as necessary. Extending the
levelling leg more than necessary
can cause the dryer to vibrate.
English 23
2021/8/12 16:19:17