Troubleshooting
Problem
Monitor or
viewfinder is blank.
Monitor is hard to
see.
The viewfinder is
hard to see.
Display does not
switch to monitor
(or viewfinder)
when the x
button is pressed.
Date and time of
recording are not
correct.
No information
displayed in
monitor.
Print date not
available.
F8
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power: Press the power switch,
shutter-release button, c button or b (e movie-record)
button, or rotate the mode dial.
• Monitor and viewfinder cannot be used simultaneously. Press
the x button to alternate between displays.
• Camera and computer are connected via USB cable.
• Camera and TV are connected via audio/video cable or HDMI
cable.
• Interval timer shooting in progress.
• Ambient lighting too bright: move to darker location or use
viewfinder.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• Adjust diopter adjustment control.
• You cannot switch the display in the following situations:
- While recording or playing back movies
- While recording or playing back voice memos
- During interval timer shooting
- While connected to a printer
• You cannot switch the display while displaying a certain error
message.
• If the camera clock has not been set ("Date not set" indicator
flashes during shooting), still pictures have a time stamp of
"00/00/0000 00:00"; and movies are dated "01/01/12 00:00. " Set
the correct date and time using Time zone and date in the
setup menu.
• The camera clock is not as accurate as a normal clock, such as
watches. Check camera clock regularly against more accurate
timepieces and reset as required.
Shooting and photo information may be hidden. Press the s
button until shooting data or photo information is displayed.
Time zone and date in the setup menu has not been set.
Cause/Solution
A
25
24
25
16
90, 93
90, E23
E43
16
108, E78
F6
16
96, 100
88
61
90
–
26, 108
E75
108,
E75
15
26, 108,
E75