Table of Contents
Advertisement
careful, as flaps are fragile and may break off easily.
You can then lift out the entire innards of the heater
(heat exchanger, fan motor, etc.) removing the cable
from the rubber securing bush and rerouting it
underneath the fan motor where it can then sit in the
cut-out on the opposite side. Ensure the rubber bush
is properly inserted and the heat exchanger is back
securely in position, then simply replace the lid and
grill back in position.
NOTE
Ensure the bottom cover fits correctly inside
the groove of the lid.
Installation: Mounting
The chosen mounting surface should be flat, and you
will need to drill the appropriate size hole for the
exhaust, combustion air inlet, fuel inlet and mounting
bolts. It is a good idea to mount the heater on the
supplied mounting bracket, particularly if the original
mounting surface is thinner than 1.5mm.
Figure VI: Mounting Gasket and Plate
A
A. Mounting Gasket
B. Mounting Plate
NOTE
The mounting plate shown in figure VI may
differ in overall size and the circular flange
may not be present, however the heater
footprint will remain the same.
Page 7 of 19
B
Advertisement
Table of Contents
