Table of Contents
Advertisement
Fault
Programme starts
automatically.
Appliance stops dur-
ing the programme or
cuts out.
Basic settings cannot
be changed.
Fault
Appliance door can-
not be closed.
Lid on the detergent
dispenser cannot be
closed.
Fault
Filling valves making
knocking noises.
Knocking or rattling
noise.
Cause and troubleshooting
You did not wait until programme ended.
→ "Terminate programme", Page 30
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
Check whether the rear panel of the appliance is
▶
being pressed in by a socket or hose holder that
has not been removed.
Arrange the tableware so that no parts project bey-
▶
ond the basket and prevent the appliance door
from closing properly.
A programme is currently running. Changing basic
settings is only possible at the start of a programme.
Cause and troubleshooting
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.
Check whether the appliance has been installed
▶
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
Remove detergent residue.
▶
Cause and troubleshooting
Caused by the domestic installation. No appliance
fault present. Does not affect functioning of the appli-
ance.
Can only be remedied in the domestic installation.
▶
Spray arm is striking tableware.
Arrange tableware so that the spray arms do not
▶
strike tableware.
With a small load the water jets directly strike against
the tub.
Troubleshooting en
45
Advertisement
Table of Contents
