Table of Contents
Advertisement
AP mode.
Manually enable or cancel ISC.
Q3: Failed to enable ICS.
A3: Microsoft ICS service can only combine one group of WAN and LAN. This message indicates
ICS may have been enabled by other network adapters.
1. Please manually cancel or restart and cancel ICS, then re-switch to AP mode.
2. This dialogue box appears because virtual wi-fi miniport adapter can only be used by one wireless
network adapter at a time. Please disable any other non-the wireless network adapters and re-switch
to AP mode.
Q4: Under Windows 7, when I switch from station mode to AP mode, the screen flashes
"DisablingICS, please wait......"and immediately return to station screen.
A4: This is because you have disabled "Microsoft Virtual WiFi Miniport Adapter", please re-enable
it and then switch to AP mode.
Q5:Client cannot obtain IP when connected to soft AP of the wireless network adapter.
A5: Manually set an IP address at the same net segment as that of the AP and the gateway and DNS
at the IP address of AP.Thus, communication can be achieved.
Q6: The SSID is not fully displayed on the wireless network list, what should I do?
A6: Keep the mouse on the displayed SSID for about 2 seconds, as the below picture shows, and
you'll see the full SSID on the appearing box.
24
Advertisement
Table of Contents
