Craftsman 580.7523 User Manual page 10

9. Move throttle lever ( A)to"Fast" p osition, shown a sa
rabbit.
10. Move choke lever (B) to "Closed"
position.
12. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance.Then pull rapidly
to start engine.
CLOSED
NOTE:For a warm engine, be sure the choke lever is in the
"Open" position.
11. Move engine switch (6) to "On" position.
OFF
ON
IMPORTANT:Before starting the pressure washer, be sure
/ou are wearing adequatesafety goggles.
WARHIHG
,_ Risk of eye injury.
_Spray can splash back or propel objects.
Alwayswearsafetygoggleswhenusingthis equipment o r in
vicinity of whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyou are wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
WARHIHG
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
_,_.< toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
* NEVER pull startercord withoutfirst relievingspraygun
pressure.
* Whenstartingengine,pull cord slowlyuntil resistance is felt
andthen pull rapidlyto avoidkickback.
* After eachstartingattempt,whereengine fails to run, always
pointspraygun in safedirection,pressred buttonand squeeze
sprayguntriggerto release high pressure.
* Firmlygraspspraygunwith both handswhenusing high
pressure sprayto avoidinjury whenspraygun kicks back.
13. Return recoil starter slowly. DO NOT let rope "snap
back" against starter.
14. When engine starts, slowly move choke lever to "Open"
position as engine warms. If engine falters, move choke
lever to "Closed" position, then to "Open" position.
15. If engine fires, but does not continue to run,always point
gun in safe direction, press red botton and squeezespray
gun trigger to releasehigh pressure. Move choke lever to
"Open" position, and repeatsteps 12 through 14.
16. If engine fails to start after six pulls, move choke lever to
"Open" position, and repeatsteps 12 through 14.
NOTE:Always keepthe throttle lever in the "Fast" position
when operating the pressure washer.
10