Handling And Operation; Before Initial Use; Operation - Silvercrest SPM 2000 E2 Operating Instructions Manual

Handling and operation

This section provides you with important information on handling and using the
appliance.

Before initial use

♦ Clean all accessories as described in the section "Cleaning and care" to
remove any possible production residues.
♦ Read these operating instructions carefully.
♦ Set up the appliance in accordance with the safety instructions.
Open the safety catch 3 by moving the slider from the
♦
the position.
♦ Clean the appliance with a damp cloth as described in "Cleaning and Care".
♦ Close the appliance.
♦ Insert the mains cable plug in a properly connected and earthed mains power
socket which supplies the voltage stated in the"Technical data" section. Allow the
appliance to heat up for approx. 5 minutes.
NOTE
► The first time the appliance heats up, a small amount of smoke and odour
may be generated due to production-related residue. This is normal and is
completely harmless. Provide sufficient ventilation; for example, by opening
a window.
♦ After heating, pull the plug out of the mains socket and allow the appliance to
cool down completely.
♦ Clean the appliance again with a damp cloth.

Operation

Close the appliance lid using the handle 4.
♦
Slide the fat collector tray 5 into the appliance.
♦
Replace the plug in the mains power socket. The red "Power" control lamp 1
♦
lights up.
As soon as the appliance has heated up, the red "Power" control lamp 1 goes
♦
out and the green "Ready" control light 2 lights up.
SPM 2000 E2
position to
GB │ IE
│
9 ■