Ryobi RBV3600 Instructions Manual page 13

GETTING STARTED
3
2
1
Connect the high speed nozzle/lower blower tube to the upper blower tube, then push until you hear an audible click, and
the tube locks into place. Connect the high speed nozzle/blower tube to the housing opening, then push the nozzle/blower
tube until you hear an audible click and the tube locks into place.
8 9
1
2
Hook the harness to the front handle. Pull the quick release handle to easily remove the harness
from the product.
GETTING STARTED
4
Push the lower vacuum tube into the upper vacuum tube
until you hear an audible click and the tube locks into
place .
10a
1
2
Set the mode selection lever to the bottom position to set
the product to blower mode.
GETTING STARTED
5 6
2
1
Turn the locking screw counterclockwise to unlock the fan Push the lower/upper vacuum tube into the fan housing
cover. Rotate the fan cover upward to open the fan housing. until it clicks into place. Slide the lock lever to the lock
position to secure the vacuum tubes. Rotate the fan cover
downward until it rests on the upper vacuum tube. Hook the
lock clip to the fan cover and press the lock clip downward
to secure the fan cover.
NOTE: Ensure that the vacuum tube is inserted correctly,
and that the lock clip is secure and tight.
11
10b
Set the mode selection lever to the top position to set the At the rear side of the housing, insert the battery pack until
product to vacuum mode. you hear an audible click and the battery locks into place.
4
5
2
3
1
WARNING: Never operate the vacuum with only the
upper vacuum tube fitted. Failure to follow this warning
increases the risk of personal injury and damage to the
product.
12
2
1
Squeeze the trigger to operate the product. Use the cruise
control lever to lock the product to the desired power.
11