Emptying The Dirt Container And Cleaning The Filter; Cleaning The Appliance; Cleaning The Rotary Brush - Silvercrest 321850 1901 Operating Instructions Manual

Emptying the dirt container and
cleaning the filter
NOTE
► To achieve the best results, empty the dirt
container 8 and clean the HEPA filter 6
regularly .
► If you need a new HEPA filter 6, please
contact our service department (see section
"Ordering spare parts") .
1) To open the dirt container 8, remove the hand
element 4 from the hand element recess r .
2) Press the release button
time, pull the dirt container 8 forwards and
off .
3) Start by pulling the HEPA filter 6 and then the
coarse filter 7 out of the dirt container 8 (fig .
3) . Tap out both parts over a rubbish bin or
similar . If necessary, you can rinse out the
HEPA filter 6 with fresh water . Allow it to air
dry fully afterwards .
Fig . 3
4) Empty the dirt container 8 into the rubbish bin
or similar .
5) First re-insert the coarse filter 7 and then the
dry HEPA filter 6 .
6) Replace the dirt container 8 onto the hand
element 4 by first pushing the lower catch on
the hand element 4 into the recess on the dirt
container 8 . Then, press the upper part of the
dirt container 8 onto the hand element 4
until the dirt container 8 clicks into place and
sits firmly .
■ 8 │ GB │ IE │ NI │ CY
5 and, at the same

Cleaning the appliance

Wipe the appliance with a damp cloth . For
stubborn dirt, add a little mild detergent to the
cloth . Ensure that the appliance is completely dry
before the next use .

Cleaning the rotary brush

The rotary brush t should be checked regularly
for blockages, and any hairs, threads or dirt should
be removed . Remove the rotary brush t as
follows:
1) Turn the floor nozzle upside down .
2) Push the catch on the cover plate towards the
symbol so that you can remove the cover
plate (fig . 4) .
3) Lift out the rotary brush t .
4) Remove dirt (on both sides of the bristles) and
clean the rotary brush t . To do this, take a
damp cloth and wipe the individual bristle
bundles from the inside to the outside .
WARNING! RISK OF INJURY!
► Be careful when handling the knife h .
The blade is very sharp!
NOTE
► You can use the knife h to remove stuck hair
and threads:
–
Fold the blade of the knife h carefully out of
the handle and cut stuck hair and threads .
–
Fold the blade back in . When doing so, only
touch the blunt edge of the blade! Risk of
injury!
–
Remove the cut hairs and threads from the
rotary brush t .
SHSS 16 A1