Cleaning; Emptying The Dirt Container And Cleaning The Filter - Silvercrest SAST 18 A1 Operating Instructions Manual

Cordless wet & dry hand-held vacuum cleaner
Hide thumbs Also See for SAST 18 A1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24

Cleaning

ATTENTION! PROPERTY DAMAGE!
Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
Emptying the dirt container and cleaning the filter
NOTE
To achieve the best results, empty the dirt container
filter
If you need a new HEPA filter
(see section "Ordering spare parts").
1) If you have not already done so, disconnect the appliance from the mains
adapter
2) To open the dirt container
dirt container
3) Remove the filter holder
container
4) Empty the dirt container
5) Remove the HEPA filter
anticlockwise towards the
6) Tap out the HEPA filter
necessary, you can rinse out the filter holder 
fresh water. Before replacing the parts ensure that they are completely dry.
Do not dry the HEPA filter
7) Reinsert the filter holder
filter holder
8) Insert the HEPA filter
HEPA filter
The arrow on the HEPA filter
holder
9) Replace the dirt container
First, place the contacts on the underside of the dirt container
the contact pins on the underside of the motor unit
two catches on the motor unit
container 
Press the upper side of the dirt container
the motor unit
container 
GB │ IE
34 
z
regularly.
0
or lift it off the wall bracket
i
i
from the appliance.
u
i
by pulling both straight out of the dirt container
i
z
from the filter holder
z
and the filter holder
z
u
u
is straight and that the rubber lip seals the dirt container
z
into the filter holder
z
fit into the corresponding recesses on the filter holder
u
. Turn the HEPA filter
i
i
.
r
so that the catch audibly engages. The dirt
i
is now firmly seated on the motor unit
z
, please contact our service department
7
.
, press the release button
together with the HEPA filter
.
u
symbol and pulling it out.
u
u
and the HEPA filter
with hot air.
into the dirt container
u
so that the catches on the
z
must be aligned with the arrow on the filter
z
clockwise towards the
r
on the motor unit
r
into the recesses on the dirt
i
against the upper side of
i
and clean the HEPA
e
and remove the
z
from the dirt
i
.
by turning it
over a rubbish bin. If
z
with
i
. Make sure that the
u
.
symbol.
:
i
onto
r
. This pushes the
r
.
SAST 18 A1
i
.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

338031 2001

Table of Contents