Operation; Using The Hand Element With The Handle; Using The Hand Element; Cleaning And Maintenance - Silvercrest 321850 1901 Operating Instructions Manual

Operation

ATTENTION! PROPERTY DAMAGE!
► The suction opening must always be open
and may not be blocked . Blockages lead to
overheating and damage to the motor .
► Do not vacuum shag pile carpet with the floor
nozzle . The rotary brush t can get caught in
the carpet and block!
NOTE
► Make sure that the HEPA filter 6 and the
coarse filter 7 are always inserted before
using the appliance .
► As soon as the suction power of the appliance
begins to diminish noticeably and the charge
indicator lamp 3 flashes green, connect the
appliance to the charger p .
Using the hand element with the
handle
1) Insert the hand element 4 into the hand
element recess r as described in the chapter
"Assembly/disassembly" .
2) Fold out the grip q on the handle by pressing
the release button
pulling the grip q upwards .
3) Switch on the appliance using the On/Off
switch 9 . The charge indicator lamp 3
lights up green, the LED light z on the floor
nozzle lights up and the rotary brush t starts
turning .
NOTE
► Press the ECO button 0 to switch to the
energy-saving ECO mode . The appliance
now uses a lower suction power but can run
for longer .
Press the ECO button 0 again to work at full
suction power .
4) Guide the floor nozzle over the area to be
vacuumed . Hold the grip q so that the floor
nozzle moves smoothly over the floor .
SHSS 16 A1
w and, at the same time,
5) Press the On/Off switch
finished vacuuming . The rotary brush t stops,
the charge indicator lamp 3 and the LED
light z go out .

Using the hand element

1) Remove the hand element 4 from the hand
element recess r as described in the chapter
"Assembly/disassembly" .
2) If required, you can attach the crevice tool i,
the brush attachment u or the upholstery
nozzle o .
3) Press the On/Off switch
element 4 to start vacuuming the desired
areas . The charge indicator lamp 3 lights
up during operation .
4) When you are finished vacuuming, press the
On/Off switch
indicator lamp 3 goes out .

Cleaning and maintenance

WARNING! RISK OF INJURY!
► Always unplug the charger p from the
mains . Pull the barrel plug a out of the
charging socket f on the cradle g before
cleaning the cradle g .
► Always remove the hand element 4 from the
hand element recess r on the handle before
cleaning
-- the hand element 4,
-- the handle or
-- the rotary brush t .
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials . These can damage the surface of
the appliance!
NOTE
► The LED light z is maintenance-free .
The LEDs cannot be changed!
9 when you have
2 on the hand
2 again . The charge
GB │ IE │ NI │ CY │ 7 ■