HOMCOM 820-260V70 Using Instructions page 4

1. Press the button to turn the appliance on. If there is no other operation, it will enter the
default mode, which is high grade (default temperature is 25°C). The mode button will light and
the middle display will show '3'. After three seconds, the display will show the temperature
setting.
2. Press the button again to put the product on standby.
3. Press and hold the power button to enter ' self test ' - the display screen will go off after two
seconds, whilst the high and low heating tubes will heat up for two seconds, then return to
standby.
4. When in its normal state, it will act as a switch. When turned off and then turned back on,
the product will remember the last mode used (the timer function is not memorised).
Mode button:
1. When plugged in, press the power button to turn the appliance on (default temperature is
25°C). The order is high, medium, low ECO and high. The middle display shows '3, 2, 1' and
then 'ECO 3' in that order.
2 . When the mode is set, press the increase/decrease button to change the temperature.
3. When the mode is set, the indicator light in the middle of the mode button is highlighted.
The middle bit of the nixie tube shows the current setting, then it will show the set temperature
after three seconds.
4. The modes consist of low, medium and high. When in one of these modes, the temperature
can be set between 15-35°C. The current setting of the heating tube can be controlled
according to the set temperature and the temperature of the NTC probe. To do this, first press
the temperature button, then press the increase/decrease button to set the temperature – it
will automatically confirm after five seconds of no operation or directly press the temperature
button to confirm.
5. When in ECO mode, the temperature can be set between 15-35°C. The heater
automatically controls the switch of the heating tube according to the set temperature and
NTC probe temperature. The set temperature will automatically dop by 1°C every hour. It can
only be reduced manually by 5°C, with the minimum being 15°C.
Timing key:
1. Press the time button to set the timer – when it reaches zero, the appliance will turn off
automatically. The indicator light in the middle of the time button is highlighted –the time
content is shown on the three-digit digital tube. The first two parts show the hour and the last
part shows 'h'.
2. Adjust the time by pressing the button – it will confirm automatically after five seconds of no
operation or press the time button to confirm(set between 0-24 hours).
3. No matter what mode the heater is in, a timer can be set to turn the appliance off
automatically.
4. Once the timer has been set, the indicator light in the middle of the time button is highlighted
(when the timer is set to 0, the indicator will turn off).