Table of Contents
Advertisement
[Front Panel]
1. Power Switch
Press to turn ON the power.
Press again to turn off the power.
2. Power Indicator
Light green when power is switch on.
3. Signal Indicator
Light green to indicate the presence of an output
signal.
4. Clip Indicator
Light red to indicate the output signal has
exceeded its rated. The sound start to distorted.
In such case, adjust each volume control so that
the clip indicatoris not light ON.
5. Volume Control for MIC
Adjust the microphone level input.
6. Volume Control for AUX
Adjust the AUX level input.
7. Low Frequency Control
Turn the control knob clockwise to enhance low
frequency and counterclockwise to weaken them.
The frequency is flat at the center position.
8. Middle Frequency Control
Turn the control knob clockwise to enhance
middle frequency and counterclockwise to weaken
them. The frequency is flat at the center position.
9. High Frequency Control
Turn the control knob clockwise to enhance high
frequency and counterclockwise to weaken them.
The frequency is flat at the center position.
10. MIC 1 - 3 Effect Control
Adjusts effect response.
Turn the control knob clockwise to strengthen the
response on the effect selected by the Effect
Present
type
selection
counterclockwise to weaken it.
Turning the control fully counterclockwise provides
no effect response.
5
12
7
11. Effect Preset type Selection Switch
12. Effect Room size/Delay time Selection Switch
switch
(11)
and
6
16
HIGH
13
14
Select the type of the sound effect from
"DOME","HALL","PLATE" and "DELAY".
Select the reverberation / delay of effect from
"S" (Short time), "M" (Medium time), "L" (Long time).
When set to OFF, the effect function is disabled.
13. Siren Switch
Push the switch to activate the sound of a siren.
When the siren is active then all input will be muted,
but all input still be active on line output
terminal.
One push is one cycle sound of the siren.
Note
No sound of the siren out from the line output
terminal.
14. Volume Control for Siren
Adjust the siren level.
15. Master Volume Control
Adjust overall signal level.
Note
This master volume control will not affect to the
sound of a siren level.
16. Zone Selector Knob
Push the knob to activate each correspondent Zone
Terminal.
2 3 4
POWER
15
1
Advertisement
Table of Contents
