Traxxas 68277-4 Owner's Manual page 26

26 • SLASH 4X4 ULTIMATE
maintaining your model
Suspension and slipper clutch assembly removal
The Slash 4X4 Ultimate was designed with ease of disassembly in mind. The entire front and rear suspension
assemblies can be removed from the chassis fully intact with the removal of only a few screws. Refer to
the exploded views included in the Slash 4X4 Ultimate Service and Support Guide for complete assembly
diagrams.
• Removing the front suspension module
1. Remove the 3x15 button-head cap screw from the steering link under the chassis.
2. Remove the two 3x6 flat-head cap screws from the front chassis.
3. Remove the two 4x12 button-head cap screws from the front of the chassis.
4. Remove the two 4x10 button-head cap screws from the top of the chassis.
5. Pull the front suspension assembly away from the chassis.
• Removing the rear suspension module
(Slipper clutch assembly removal)
1. Remove the two 4x12 button-head cap screws from the top of the chassis.
2. Remove the two 4x14 button-head cap screws from the bottom of the chassis.
3. Pull the rear suspension assembly away from the chassis.
4. The slipper clutch assembly can now be removed.
4x12BCS
3x6 FCS
Front Suspension
Assembly
4x10BCS
Slipper Clutch
Assembly
4x12BCS
3x15BCS
Rear Suspension
Assembly
4x14BCS