ESC/Motor Wiring Diagram
12 • SLASH 4X4 ULTIMATE
TRAXXAS TQ
RADIO & VELINEON POWER SYSTEM
i
Your model is equipped with the newest TQi 2.4GHz transmitter
with Traxxas Link
Model Memory. The transmitter has two
™
channels for controlling your throttle and steering. The receiver
inside the model has 5 output channels. Your model is equipped
with one servo and an electronic speed control.
TRANSMITTER AND RECEIVER
Set Button
Red/Green Status LED
see page 34 for more info
Menu Button
Steering
Trim
Multi-Function
Knob
Throttle
Trigger
Link
Button
Power Switch
Battery Compartment
** Accessory sensor expansion port for use with the Telemetry Expander Module
(see Traxxas.com and included materials for more information)
MODEL WIRING DIAGRAM
Steering Wheel
Antenna
VXL-3s ELECTRONIC SPEED CONTROL
Sensor Expansion
Port
**
Traxxas High-Current
Connector (Male)
to Battery
Cooling Fan
LED
Connector
(for optional use)
Receiver cable
(RX wire)
LED
Telemetry
Temperature Wire
(see sidebar for proper
Channel 1
Steering Servo
Traxxas High-Current
Connector (Male)
to Battery
Telemetry
Voltage Wire
RPM
Sensor
Cooling Fan
Connector
(for optional use)
V/T - Voltage/Temp Sensor
Channel 2
RPM - RPM Sensor
Electronic Speed Control
BATT/
CH5 - Battery/Channel 5*
CH4 - Channel 4*
CH3 - Channel 3*
CH2 - Speed Control
CH1 - Steering servo
CH1 - Steering servo*
*Not used
EZ-Set Button
(On/Off Button)
Brushless Motor
motor wiring)
Motor Cap
to Motor
Heat Sink