Traxxas Slash 4X4 VXL Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. SLASH 4x4 VXL
  6. Owner's manual

Traxxas Slash 4X4 VXL Owner's Manual

Hide thumbs Also See for Slash 4X4 VXL:
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL 68286-4
owner
s manual
'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Slash 4X4 VXL and is the answer not in the manual?

Questions and answers

Related Manuals for Traxxas Slash 4X4 VXL

Summary of Contents for Traxxas Slash 4X4 VXL

  • Page 1 MODEL 68286-4 owner s manual ’...

  • Page 2: Table Of Contents

    INTRODUCTION TABLE OF CONTENTS Thank you for purchasing the Slash 4X4 VXL equipped with the Traxxas Support Velineon Brushless Power System. The Velineon Power System ® Traxxas support is with you every step of the lets you experience the best that brushless motor technology has BEFORE YOU way.

  • Page 3: Before You Proceed

    Traxxas service needs. Maintenance and replacement Ready-To-Race, Ready-To-Win, CROSS-REFERENCES parts may be purchased directly from Traxxas by phone or online Slash, Slash 4X4, Velineon, and Throughout this manual, you’ll notice warnings and helpful hints ProGraphix are trademarks or at Traxxas.com.

  • Page 4: Safety Precautions

    SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy your new model. • Transmitter on First: Switch on your transmitter first before Operate your model sensibly and with care, and it will be exciting, switching on the speed control to prevent runaways and erratic All instructions and safe, and fun for you and those around you.
  • Page 5 • ONLY use a Traxxas iD charger to charge Traxxas iD batteries. identifying the battery type and specifications. ONLY use a Lithium Polymer (LiPo) balance charger with a •...
  • Page 6 SAFETY PRECAUTIONS (continued from previous page) • While charging or discharging, ALWAYS place the battery (all (temperature greater than 110°F / 43°C), immediately disconnect types of batteries) in a fire retardant/fire proof container and on the battery from the charger and discontinue charging. a non-flammable surface such as concrete.

  • Page 7: Tools, Supplies, And Required Equipment

    Traxxas High-Current connector* Traxxas recommends you choose a genuine Traxxas EZ-Peak® iD charger for safer charging, maximum Traxxas Power Cell LiPo iD® batteries are strongly recommended battery life, and performance for maximum performance and safer charging *Battery and charger style are subject to change and may vary from images.

  • Page 8: Anatomy Of The Slash 4X4

    ANATOMY OF THE SLASH 4X4 VXL Caster Block Battery Steering Block Rear Camber Link Hold-Down Half Shaft Traxxas iD® High- Battery Compartment Front Current Connector Suspension Arm Spur Gear Motor Front Shock Tower Rear Shock Tower Drive Shaft Chassis Shock...

  • Page 9: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.

  • Page 10: Power System

    TRAXXAS TQ RADIO & VELINEON POWER SYSTEM INTRODUCTION with each other. The VXL-3s electronic speed control is optimized Your model includes the latest Traxxas TQi 2.4GHz transmitter with Applying the Decals to virtually eliminate cogging. Traxxas Link Model Memory. The transmitter’s easy-to-use design ™...
  • Page 11 TRAXXAS TQ RADIO & VELINEON POWER SYSTEM NiMH - Abbreviation for nickel-metal hydride. Rechargeable NiMH Trim - The fine-tuning adjustment of the neutral position of the batteries offer high current handling and much greater resistance servos, made by adjusting the throttle and steering trim knobs To prevent loss of radio range to the “memory”...
  • Page 12 CH1 - Steering Servo Trim CH1 - Channel 1* † *Not used Accessory sensor ports for use with standard voltage/temperature and RPM telemetry sensors (see Traxxas.com and included materials for more information) VXL-3s ELECTRONIC SPEED CONTROL Multi-Function Knob Traxxas High-Current Sensor Expansion...
  • Page 13 Make certain you choose the correct type of charger for the batteries you light does not indicate the charge level select. Traxxas recommends you choose a genuine Traxxas EZ-Peak iD of the battery pack installed in the model. Refer to the charger for safer charging and maximum battery life and performance.
  • Page 14 RADIO & VELINEON POWER SYSTEM INSTALLING THE BODY Note: To keep the clipless system functioning properly, periodically Your Slash 4X4 VXL includes an innovative latching system for inspect and clean the latches in the body and the slots on the Battery iD securing the body to the chassis (body clips are not required).
  • Page 15 Forward determine the reason for (center) point of the steering channel. signal loss and resolve the Note: Traxxas Stability Management (TSM) problem before operating must be completely turned off while adjusting steering trim. See RADIO SYSTEM RULES your model again.
  • Page 16 TRAXXAS TQ RADIO & VELINEON POWER SYSTEM USING THE RADIO SYSTEM Range-Testing the Radio System The TQi Radio System has been pre-adjusted at the factory. The Before each running session with your model, you should range-test Using Reverse: While driving, adjustment should be checked before running the model in case of your radio system to ensure that it operates properly.
  • Page 17 3x4mm set was engineered into your Traxxas cut the metal tip, and do not screw. To remove the antenna tube, model by helping you to maintain...

  • Page 18: Adjusting The Electronic Speed Control

    To verify the Low-Voltage Detection setting: Detection setting), indicating the VXL-3s is on and at neutral (D). Battery connector: 1. Turn on the transmitter (with the throttle at neutral). Traxxas High-Current Once Green 2. Connect a fully charged battery pack to the VXL-3s. VXL-3s Operation Connector 3.
  • Page 19 ADJUSTING THE ELECTRONIC SPEED CONTROL VXL-3s Profile Selection 4. The LED will blink and then turn solid green The speed control is factory set to Profile #1 (100% forward, brakes, and reverse). (Low-Voltage Detection ACTIVE) or red (Low- Patented Training Mode To disable reverse (Profile #2) or to allow 50% forward and 50% reverse (Profile #3), Voltage Detection DISABLED).

  • Page 20: Driving Your Model

    RUNNING IN WET CONDITIONS • Use good, common sense whenever you are driving your model. Your new Traxxas model is designed with water-resistant features to Intentionally driving in an abusive and rough manner will only result protect the electronics in the model (receiver, servos, electronic speed in poor performance and broken parts.
  • Page 21 One way to do this is to make several high-speed passes on a flat, dry surface (if possible). • The Traxxas TQi transmitter is not water resistant. Do not subject it to 2. Remove the batteries. wet conditions such as rain.
  • Page 22 Label which wire is for which channel. 4. Apply a small bead of silicone grease (Traxxas part #1647) to the wire clamp. 5. Install the wire clamp and tighten the two 2.8x8mm cap screws securely.

  • Page 23: Basic Tuning Adjustments

    Rear toe-in can be adjusted settings. The more progressive using accessory rear axle suspension settings help carriers, Traxxas Part #1952X. These can add or remove 1.5° reduce body roll (increased roll toe per side, for a total of 1 to stiffness), dive during braking, 4 degrees per side.
  • Page 24 (Learn more about adjusting the slipper clutch in the sidebar.) If you have questions or need technical assistance, call Traxxas at 1-888-TRAXXAS (1-888-872-9927) (U.S. residents only)

  • Page 25: Maintaining Your Model

    • Steering: Over time, you may notice increased looseness in the steering Assembly installed into these holes to system. The tie rod ends may wear out from use (Traxxas Parts #2742 and limit dirt entry. Use Traxxas #5525). Replace these components as needed to restore factory tolerances.

  • Page 26: Advanced Tuning Adjustments

    ADVANCED TUNING ADJUSTMENTS CAMBER GAIN Gearing Compatibility Chart: • Front Roll Center Front C-hub The chart below shows recommended Slash 4x4 has provisions for adjusting the camber gain geometry of the To lower the roll center gear combination ranges for your model. front and rear suspension.
  • Page 27 ADVANCED TUNING ADJUSTMENTS GEARING LIPO BATTERIES One of the more significant advantages to your model’s transmission LiPo batteries are intended only for the most advanced users that are Velineon 3500 Specs is the extremely wide range of available gear ratios. Changing the educated on the risks associated with LiPo battery use.
  • Page 28 Do not remove the two screws that secure the shock tower. Only use silicone oil in the differentials. Traxxas offers SAE 10,000W, 7. Use a 1.5mm hex wrench to remove the two screw pins that hold 30,000W, and 50,000W viscosity oil (see your parts list).
  • Page 29 ADVANCED TUNING ADJUSTMENTS Rear differential: Refilling the differential: 1. Remove the two 3x20mm button-head screws that secure the 1. Remove the four 2.5x10mm screws from the differential case top bumper mount to diff case. and carefully pull the diff case halves apart. Work over a towel to collect any fluid that drips from the differential.

  • Page 30: Tq Advanced Tuning Guide

    (set to The Multi-Function knob can be set to control Throttle Sensitivity. Starting Over: Traxxas Stability Management (TSM) by default, see page 17). Accessing Throttle Sensitivity works the same way as Steering Sensitivity, but Restoring Factory Defaults the programming menu is done by using the menu and set buttons on applies the effect to the throttle channel.
  • Page 31 This is especially handy if you operate multiple vehicles equipped with a built-in failsafe This allows you to fine-tune the servo settings to prevent binding with a single transmitter via Traxxas Link ™ Model Memory. function that returns the throttle...
  • Page 32 Model Lock Press and hold MENU to return to driving mode. The Traxxas Link Model Memory feature can store up to thirty models Note: To unlock a memory, press SET twice at step 5. The LED will (receivers) in its memory. If you bind a thirty-first receiver, Traxxas Link blink rapidly green to indicate the model is unlocked.
  • Page 33 Transmitter is restored to default Press Delete Model C onfirm Deletion Two Blinks Green One Blink Red *Torque Control is a feature designed only for use with the power system in the Traxxas Funny Car Race Replica (Model #6907).
  • Page 34 ADVANCED TUNING GUIDE MENU TREE FORMULAS Set Multi-Function knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the Menu Tree, turn your transmitter on, find the function in the...
  • Page 35 Traxxas Link Real-Time Telemetry For more information The powerful Traxxas Link app (available in the Apple App Store℠ or on about the Traxxas Link When you equip your model Google Play™) gives you complete control over the operation and tuning...
  • Page 36 ’ 6250 TRAXXAS WAY, McKINNEY, TEXAS 75070 1-888-TRAXXAS 231006 68286-4-OM-FR-R00...

This manual is also suitable for:

68286-4

Table of Contents

Save PDF