Table of Contents
Advertisement
Battery iD
Traxxas recommended
battery packs are equipped
with Traxxas Battery iD. This
exclusive feature allows
Traxxas battery chargers (sold
separately) to automatically
recognize connected battery
packs and optimize the
charge settings for the
battery. This eliminates
the need to worry over
charger settings and menus
for the easiest and safest
charging solution possible.
Visit Traxxas.com to learn
more about this feature and
available Traxxas iD chargers
and batteries.
Battery Compartment Specs:
• 166mm (6.54") long
x 49.5mm (1.95") wide
• Height with stock strap:
23mm (.91") or 25mm (.94")
• Height with Part #7426X
options battery standoffs:
Up to 44mm (1.73")
Note: There is some flex with
the battery strap. It is possible
to fit slightly taller batteries in
the compartment.
4 4
14 • SLASH 4X4 ULTIMATE
TRAXXAS TQ
RADIO & VELINEON POWER SYSTEM
i
INSTALLING THE BODY
Your Slash 4X4 Ultimate includes an innovative latching system for
securing the body to the chassis (body clips are not required).
To remove the body for chassis access:
1. Reach beneath the truck body and pull the latches toward the
outside of the truck body to release them from the front and rear
body mounts.
2. Push up on the latches to fully disengage them from the mounts.
3. Lift the body straight up from the chassis. Lift the front and rear of
the body evenly or it may become difficult to remove.
To reinstall the body:
1. Position the body on the chassis. Align the front and rear of the
body with the bumpers.
2. Press down on the body at each latch location until the latches
snap into place.
Note: To keep the clipless system functioning properly, periodically inspect
and clean the latches in the body and the slots on the front and rear body
mounts. If dirt and grime accumulate on these components, the clipless
system will not operate smoothly.
INSTALLING THE BATTERY PACK
Install the battery pack with the battery
wires facing the rear of the model.
Insert the tabs of the battery hold-
down into the slots in the rear hold-
down retainer (A). Swing the battery
hold down towards the chassis and
snap (lock) the end into the front hold-
down retainer (B).
The Traxxas High-Current Connector
Your model is equipped with the Traxxas
High-Current Connector. Standard
connectors restrict current flow and are not
capable of delivering the power needed
to maximize the output of the VXL-3s. The
Traxxas connector's gold-plated terminals, with large contact surfaces,
ensure positive current flow with the least amount of resistance. Secure,
long-lasting, and easy to grip, the Traxxas connector is engineered to
extract all the power your battery has to give.
Advertisement
Table of Contents
