Beko WUE7626XBWST User Manual page 22

C
INFORMATION
• If the programme has not started, you can add laundry into the machine during the delayed end
time.
5. At the end of the countdown, duration of the selected programme will be displayed. "_" will
disappear and the selected programme will start.
Changing the delayed end time
If you want to change the time during countdown: Turn the programme selection knob to cancel
the delayed end time function, and then set the desired time again.
1. Press the End Time Adjustment button. When pressed for the first time, the programme
duration will be rounded up to the closest whole number time. Each following press will
increase the time by an hour.
2. If you want to decrease the delayed end time, press the End Time Adjustment button
consecutively until the desired time is displayed.
Cancelling the delayed end function
If you want to cancel the delayed end time countdown and start the programme immediately:
1. Set the Programme Selection knob to any programme. This way, the Delayed End time will be
cancelled. The End/Cancel light will flash continuously.
2. Then, select the programme you want to run again.
3. Press Start/Pause button to start the programme.
4.3.12 Starting the programme
1. Press Start/Pause button to start the programme.
2. Programme follow-up light showing the startup of the programme will turn on.
C
INFORMATION
• If no programme is started or no key is pressed within 10 minutes during the programme
selection process, the display lights will go off. Once the Programme Selection knob is turned or
any button is pressed, display lights will turn on again.
4.3.13 Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator.
At the beginning of each programme step, the relevant indicator light will turn on.
C
INFORMATION
• If the "Anti-crease+" auxiliary function has been selected, "End" LED and "Anti-crease+" LED will
be on at the same time while this step is continuing.
• To end the programme while the "Anti-crease+" step is running, simply press any button or turn
the programme selection knob.
You can change the auxiliary functions, speed and temperature settings without stopping
the programme flow while the programme is running. To do this, the change you are going to
make must be something that will be carried out after the programme step that is running. If
the change is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the spinning step, the Rinse Hold function might be active
or the automatic unbalanced load detection system might be activated due to the unbalanced
distribution of the laundry in the machine.
22 / EN
Washing Machine / User's Manual