Panasonic SD-YD250 Manual page 27

Motor operation test table
1 Forward (clockwise) revolution
for 1.0 seconds.
2 1.0 seconds off.
3 Continuous forward (clockwise) revolution.
4 Stop for ten minute after, and initial test mode
will light up.
6.2.2. RISE mode confirmation test.
1. From the Initial test
2. The LCD indication shown in will appear, and the operation LED
(Red) will light up.
3. Next, the temperature will be adjusted at relay current flow ratio of
3.2/32 (10 percent) in order to maintain a bread case temperature
of approximately 95°F (35.0°C). / Inorder to measure the rising
temperature of the Bread pan thermometer. / Allow the unit to sit
in this condition for at least approximately one hour, check the
temperature in the bread pan with a mercury thermometer. / The
unit is functioning properlyif the temperature is between 88°F
(31°C) and 102°F (39°C).
4. To return to
Motor operation test LCD
2 times
repeat
mode, press the "TIMER" pad once.
Initial test mode, press "Start/Stop" pad once.
RISE mode confirmation test LCD
27