Table of Contents
Advertisement
USING THE PROJECTOR
Powering off
1.
Turn off the projector by pressing the "
2.
The following message will be displayed:
3.
Press the "
you press the "
4.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/
Standby LED will flash blue. When the On/Standby LED turns solid red, this indicates the projector has
entered standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle
has finished and the projector has entered standby mode. When the projector is in standby mode,
simply press the "
5.
Disconnect the power lead from the electrical outlet and the projector.
Note:
It is not recommended that the projector is turned on immediately, right after a power off procedure.
22
English
Power Off
Power Off?
Press power key again.
" button again to confirm, otherwise the message will disappear after 15 seconds. When
" button for the second time, the projector will shut down.
" button again to turn on the projector.
" button on the projector keypad or the remote control.
Advertisement
Table of Contents
