Gourmia GDK260 - Digital Kettle Manual

FEATURES AND FUNCTIONS

1. Lid
2. Control Panel
3. Handle
4. Power Cord
5. Spout
6. Water Gauge
7. Body
8. Base

CONTROL PANEL

OPERATING INSTRUCTIONS

BEFORE USING FOR THE FIRST TIME

1. Remove all of the various packaging, stickers or accessories from both the inside and outside of the kettle.
2. Adjust the length of the cord by winding it under the base. Wedge the cord into the notch.

BOILING WATER

1. Open the lid of the kettle, add water and close the lid. Note: You must add at least enough water to go above the Min level but less than the Max level.
2. Plug the base into the electrical outlet and place the filled kettle onto the base. The kettle is on standby and only the I/O and + & - buttons can be used.
3. Choose the desired water temperature:
   • Boil water: Press I/O. The kettle will begin the boiling process.
   • Heat water to a specific water temperature: Press + or – and a temperature appears on the LCD starting with 104°F. Press + or – again to increase or decrease the desired water temperature. Press I/O and the kettle begins to heat the water.
     Note: If you don't press I/O within 10 seconds, the kettle returns to standby mode.
4. At any time during the boiling process, you can increase or decrease the desired water temperature by pressing + or –.
5. Once the water reaches the desired temperature, the kettle stops the process. After approximately 2 minutes, the LED display turns off and the kettle returns to standby mode.

HOLDING HOT WATER AT A SPECIFIC TEMPERATURE

1. Fill with water up to Max level.
2. Press the Keep Warm button, and press + or – to increase or decrease the desired water temperature.
   Note: The highest temperature that the kettle can hold is 194°F.
3. Press I/O. The kettle starts the boiling process. When the water reaches the desired temperature, the kettle holds the water at that temperature for 4 hours.
   Note: If you don't press I/O within 10 seconds, the kettle returns to standby mode.
   At any time during the boiling process, you can increase or decrease the desired water temperature by pressing + or –.

CLEANING AND MAINTENANCE

CLEANING YOUR KETTLE

• Before cleaning the kettle, make sure it is unplugged from any electrical outlets. Also, let the kettle cool down before cleaning.
• Do not immerse the kettle, the power cord, power plug, or power socket into water.
• Wipe the outside of the kettle with a damp cloth.
• Do not use a scouring powder or other cleaning product on the kettle as it could damage the surface.

DESCALING

To keep the kettle working well, you should descale regularly, preferably at least once a month or more frequently if your water is very hard.

There are three different ways you can descale your kettle:

Using white vinegar:

1. Fill the kettle with 2 cups of vinegar.
2. Let the vinegar soak in the kettle for 1 hour. Do not turn on the kettle during this time.
3. Pour out the liquid and rinse 5 or 6 times.

Using citric acid:

1. Boil 2 cups of water in the kettle.
2. Add 5 teaspoons of citric acid and let it soak for 15 minutes.
3. Pour out the liquid and rinse 5 or 6 times.

Using a descaler:

1. Use a descaler specifically for plastic kettles and follow the manufacturer's instructions.
2. Empty your kettle and rinse 5 or 6 times. Repeat if necessary.

TROUBLE SHOOTING

In the unlikely event that you experience a problem with your device, please take a couple of minutes to check these possible causes prior to contacting customer support.

Problem:

The kettle does not work or stops before coming to the boil.

Possible Causes:

• Check that your kettle is properly connected.
• The kettle has been switched on without water.
• An accumulation of scale has caused the overheat cut-out to operate.

Solutions:

• Allow the kettle to cool for at least 15 minutes and fill it with water.
• Descale first if scale has accumulated.
• Switch the kettle on.

Problem:

The water tastes of plastic.

Possible Causes:

Generally, this happens when the kettle is new.

Solutions:

Discard the water from the first few boilings.

If the problem persists, fill the kettle to maximum and add two teaspoons of baking soda. Bring to a boil and descale the water. Rinse the kettle thoroughly.

Problem:

The kettle has been dropped, it leaks, or there is damage to the power cord, plug, or base of the kettle.

Solutions:

• Do not use the kettle. No attempt must be made to dismantle the kettle or its safety devices.
• If the supply cord is damaged, it must be replaced by the manufacturer, its after-sales service center or a similarly qualified person, in order to avoid any danger.
• Return your kettle to your local After-Sales Service Center; only they are authorized to carry out repairs. See the guarantee conditions and list of centers in the booklet supplied with your kettle. The type and serial number are shown on the bottom of your kettle. This guarantee covers manufacturing defects and domestic use only. Any breakage or damage resulting from failure to comply with the instructions for use is not covered by the guarantee.
• Reserves the right to modify the characteristics or components of its kettles at any time in the interest of the consumer.

ACCIDENT PREVENTION

• Position the kettle and its supply cord well to the rear of the work surface, out of the reach of children.
• If an accident does occur, run cold water over the scald immediately and call a doctor if necessary.
• For a child, a burn or scald, even if slight, can sometimes be serious.
• In order to avoid any accident: do not carry your child or baby at the same time as drinking or carrying a hot drink.

IMPORTANT SAFEGUARDS

When operating this electric appliance, basic safety instructions should always be followed. Refer to the following for these instructions

1. READ ALL SAFETY & USAGE INSTRUCTIONS BEFORE USING.
2. Keep children away from the machine when in use.
3. Never operate the appliance with a damaged cord or plug or one that has malfunctioned or been damaged in any way. If necessary, immediately contact Customer Service for assistance.
4. The kettle should not be used with an external timer or a separate remote control system.
5. Operate the appliance on a level surface well away from any hot gas or electrical burner, heat source, combustible spray cans or pressurized items.
6. To avoid injury or death from electrical shock, do not operate the machine with wet hands, while standing on a wet surface or while standing in water. Also, do not use the machine outdoors or in wet conditions.
7. Do not immerse the machine directly in water to clean.
8. Do not fill the water to higher than the maximum water level.
9. When filling the kettle, make sure it is not plugged in to an electrical outlet.
10. Make sure the lid is closed before boiling water. Do not open the lid until the boiling is finished.
11. Make sure the power to the kettle is turned off before removing the base.
12. When not in use, unplug the kettle.
13. Only use the base that accompanied the kettle.
14. This machine is for household use only. Any other use will void the warranty.

SAVE THESE INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

Electrical 3-conductor Cord Set

Appliance is equipped with a 3-conductor cord set that has a 3 prong grounding-type plug. It should be properly connected to a grounding-type outlet. The plug is designed to fit ONLY a 3-grounding outlet unit, and as such, the grounding prong should never be removed. If needed, purchase a 2-prong adapter and ground it to the outlet. Consult a qualified electrician if in doubt. Do not use an adapter unless you are confident it is grounded. Do not modify this plug. If the plug does not fit the outlet securely, call a qualified electrician for assistance.

A short power cord or a detachable power cord is provided to reduce the risks of resulting from becoming entangled in or tripping over a longer cord accidentally.

For Customer Service or Questions, Please call: 888-552-0033

www.gourmia.com