Advertisement
BEFORE USING FOR THE FIRST TIMERemove all of the various packaging, stickers, or accessories from both the inside and outside of the kettle. Fill the kettle with clean water to maximum capacity and boil. Discard the water and repeat the process. |
Note: To switch between displaying temperature in Fahrenheit and Celsius, press and hold the Temperature Button while the water is boiling. In Fahrenheit mode, the panel will display the temperature value with "°F" when the temperature is lower than 100°F, such as 99°F, but the panel will only display temperature value without "°F" when the temperature is higher or equal to 100°F, such as "140." In Celsius mode, the panel will display the temperature value with "°C" when the temperature is lower than 100°C. |
Tap the Power/Menu button to turn the kettle on. While the display is blinking, tap the Power/Menu button once to select the Keep Warm function. The Indicator Light below Keep Warm, and the display, will blink. The Keep Warm function will begin in 5 seconds.
The default Keep Warm temperature is 122°F / 50°C and the range is 86°F-194°F / 30°C-90°C. Press the Temperature Button to increase the temperature by 2 degrees Fahrenheit or 1 degree Celsius. Press and hold the Temperature Button to increase the temperature rapidly.
Once the Keep Warm function begins, the display will show the current temperature.
The default Keep Warm time is 24 hours.
Pour 3-5 tablespoons (50-80ml) of white vinegar into the kettle, then add water to the maximum line (0.6L).
Tap the Power/Menu Button to turn the kettle on. While the display is blinking, tap the Power/Menu button twice to select the Self-Clean function. The Indicator Light below Self-Clean, and the display, will blink. The function will begin in 5 seconds.
After the standard boiling time, the kettle will boil for an additional 3 minutes to remove the limescale and the kettle will stop. Pour out the water and rinse out the kettle with tap water 4-5 times.
To extend the service life of the electric kettle, descale it regularly. See "Self-Clean Function."
Unplug the power cord and cool the electric kettle before cleaning.
Don't use steel wool, detergent with chemical ingredients, or powdered detergent to clean the surface of the kettle.
The outside of the electric kettle can be wiped off with a damp cloth.
Problem | Solution |
Display Reads: E0 | The kettle is overheated. Unplug the kettle, fill with water, and allow to cool down before using. |
Water tastes like plastic | This happens when the kettle is new. Fill the kettle with clean water to maximum level and boil. Discard the water and repeat the process. |
The kettle is not turning on | Check that the power cord is properly connected. |
Contact customer service. | |
The kettle display turns on but is not boiling | Select a function and follow the instructions. |
Contact customer service. | |
Kettle turns off before water is fully boiled | Kettle needs descaling. See "Self-Clean Function." |
Contact customer service. | |
Kettle does not turn off after boiling | Contact customer service. |
If there is any damage to the kettle or power cord, contact customer service. Only authorized service centers may repair or replace. Do not attempt to dismantle the kettle in any way.
PROTECTION OF THE ENVIRONMENT
At the end of the life of your product, it should go to a specially adapted waste-recycling center.
ENVIRONMENT PROTECTION FIRST
Read the user manual carefully before using the product. Keep this user manual for future use. Ignoring the instructions or incorrect operation may result in severe accident or other injuries. When using electrical appliances, basic safety precautions should always be followed, including the following:
Do not switch on if there is a possibility that the water in the pot is frozen.
SAVE THESE INSTRUCTIONS
Appliance is equipped with a 3-prong grounding-type plug. It should be properly connected to a grounding-type outlet. The plug is designed to fit ONLY a 3-grounding outlet unit, and as such, the grounding prong should never be removed. If needed, a 2-prong adapter may be used if local codes allow it.
This kettle can be used in countries that operate on 100-120V and in countries that operate on 220-240V.
Rated Power | 100-120V 50/60Hz 700W 220-240V 50/60Hz 900W |
FOR CUSTOMER SERVICE VISIT US @ GOURMIA.COM OR CALL 888.552.0033
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the GDK368 and is the answer not in the manual?
Questions and answers