Xfinity Remote with Voice Control Start Manual

Meet Your Remote

Turn On Your Remote

Your remote arrives with the AA batteries already installed, but not activated. Here is how to power it on for the first time.

1. Pick up your remote and remove the "Pull" tab (on back) by pulling away from the remote. The Status LED will blink green four times as the remote powers up (about 5 seconds).
   
2. Turn on your TV.
3. Turn on your set-top box.
   

Pair Remote for "Aim Anywhere" Control

Control your set-top box without having to point your remote at the device, even when it is located inside a cabinet or entertainment center.

1. Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
   
2. Press the XFINITY button.
3. Follow the on-screen instructions to enter the 3-digit code that appears.
   Once the code is correctly entered, your XFINITY Remote is paired with the device.
   

Not working? Make sure the battery tab from your remote is removed, your TV is on and you are entering the correct 3-digit code on your TV screen.

Need to remove Aim Anywhere control? Press and hold the Setup button on the remote until the status LED changes from red to green. Press A on the remote. If the status LED blinks green twice, you have successfully removed Aim Anywhere.

Control Your TV's Power and Volume

1. Using the list on the right, find the first 5 digit code for your TV manufacturer.
2. Press and hold the Setup button (about 3 seconds) until the Status LED changes from red to green.
   
3. Enter the first 5-digit code for your TV manufacturer. The Status LED should flash green twice.
   
4. Verify that the code was accepted by using your remote to adjust volume and turn the TV on and off.
   

Popular Manufacturer Codes
LG 10178, 11265
Panasonic 10051, 10250
Samsung 10812, 10060
Sanyo 10154, 10159
Sony 10000, 11100
Sharp 10093, 10165
Toshiba 10156, 11156
Vizio 11758, 11756

If your code isn't listed or you would like to control an audio device, visit xfinity.com/voiceremote.

Not working? Try the second code listed. Still not working? Visit xfinity.com/voiceremote for a complete list of codes or use the My Account app for mobile (iOS/Android) or X1.

Test Voice Control

Once your remote is paired with your set-top box, you can use voice control.

1. Press and hold the Voice button until you hear the audio tone.
   
2. Speak a voice command to the remote while continuing to hold down the button. Try one of the suggestions below. The Status LED will be solid blue while you speak your command.
   WATCH CNBC
   FIND The Voice
   SHOW ME all Eagles games
   SHOW ME all kids movies on HBO
   RECORD The Biggest Loser
   LAUNCH Pandora
   GUIDE
   WHAT SHOULD I WATCH?
   WHAT'S ON NOW?
3. Release the Voice button when your command is complete. Look at the TV for the results of your voice command.

Not working? Make sure you're pressing the Voice button while you speak into the remote, and release it when complete.

Documents / Resources

References

• Xfinity Voice Remote Overview - Xfinity Support

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Xfinity Remote with Voice Control Start Manual