Vaporesso LUXE PM40 - Vape Kit Manual
Also See for LUXE PM40:

Advertisement

Vaporesso LUXE PM40 - Vape Kit Manual

INTRODUCTION

Please read this instruction carefully before use to ensure a perfect experience. If there is any additional requirement about this product, please consult the local agent or contact us through our website: www.vaporesso.com

ENLARGED VIEW

ENLARGED VIEW

USE INSTRUCTIONS

  1. Coil Installation
    Make sure the cartridge is empty before installing the coil.
    Insert the coil firmly into the cartridge.
  2. Coil Replacement
    Make sure the cartridge is empty before replacing the coil. Pull out the used coil and install a new one firmly.
    USE INSTRUCTIONS - Step 1 - Coil Replacement
  3. Fill the E-liquid
    Snap off the drip tip from the cartridge.
    Gently insert the e-liquid filling bottle tip to the filling slot.
    Squeeze the e-liquid through the slot.
    Install the drip tip back and confirm it shut firmly.
    *If it's the first time filling the e-liquid, please wait 5 minutes for the coil to prime.
    *If the drip tip cannot be installed, please adjust the installation angle. DO NOT force it in to avoid damage. DO NOT move the drip tip frequently in case of leakage.

    USE INSTRUCTIONS - Step 2 - Fill the E-liquid
  4. Install the cartridge
    Put the cartridge with installed coil onto the battery. Make sure they are firmly connected.
  5. Power On/Off
    Press the power button 5 times within 2 seconds to power on or power off the device.
  6. Lock/Unlock the system
    Press the power button 3 times continuously to unlock the system if the device is in the locked state. Without any operation within 5 seconds, the system will lock automatically.
  7. Adjust the output wattage
    Press the power button gradually in the unlocked state to adjust the output wattage.
    To avoid overheating, set the device's output wattage only within the recommended wattage output range specified for the coil.
  8. Adjust the airflow
    Adjust the airflow toggle to customize your vaping experience.
  9. Start vaping
    In the locked state, hold the power button and inhale through the drip tip. Release the power button and exhale.
  10. Charge the device
    Plug in the Type-C USB cable to charge the battery. The battery level will displayed on the OLED screen. When it's fully charged, the device will stop charging automatically.

PROTECTIONS

  1. Short-circuit Protection: If a short circuit is detected during vaping, the device will stop working and the current resistance information will flash 5 times on the screen.
  2. No Load Protection: If the coil can't be detected during vaping, the device will stop working and the resistance information will change to 9.99Ω and flash 5 times on the screen.
  3. Low Resistance Protection: If an ultra-low resistance is detected during vaping, the device will stop working and the current resistance information will flash 5 times on the screen.
  4. High Resistance Protection: If an ultra-high resistance is detected during vaping, the device will stop working and the resistance information will change to 9.99Ω and flash 5 times on the screen.
  5. Low Voltage Protection: If the battery cell working voltage is extremely low during vaping, the device can't be operated and the battery level icon will flash on the screen.
  6. Over Voltage Protection: The main MCU keeps monitoring the output voltage to ensure it does not exceed the rated voltage. If it does, the device will stop working.
  7. Over Charge Protection: When the battery cell is fully charged, the device will stop charging and display "100%" on the screen.
  8. Over Discharge Protection: When the voltage drops to a low value, the device will stop working.
  9. Auto-Shut Off Protection: The device contains an automatic shut-off feature which will disable the device if the power button is depressed for more than 5 seconds. In this event, the vaping time information will flash 3 times on the screen.
  10. PCBA Overheat Protection: If the device detects that the temperature of inner mainboard is ultra-high during vaping, it will stop working and the battery value information will change to "HEAT" and flash 5 times.

CAUTIONS

  1. Please turn off the device when it is not in use.
  2. Do not leave the charging device unattended.
  3. Do not drop, throw or abuse your device, which may cause damage.
  4. Please use a standard USB output charger with proper charging current and voltage range.
  5. Keep away from the water or any flammable gas, liquid.
  6. Do not expose the device to direct sunlight, dust, moisture or mechanical shock.
  7. Do not expose the device to extreme temperature. (Recommended temperature range: 14~140 while using and 14~113 while storing).
  8. EEE Recycling: the product should not be treated as household waste, instead, it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
  9. Battery Recycling: the product battery should not be treated as household waste, instead, it should be handed over to the applicable used battery collection point for recycling.
  10. Only have your device repaired by Vaporesso. Do not attempt to repair it by yourself as damage or personal injury may occur.

WARNINGS

cautionThis refillable electronic cigarette is intended for use with compatible e-liquid, which may contain nicotine. Nicotine is an addictive substance and it is not suitable or recommended to use in following cases:

  1. This device is not suitable for:
    • Persons under the legal smoking age.
    • Persons experiencing heart disease, stomach or duodenal ulcers, liver or kidney problems, long-term throat disease or difficult breathing due to bronchitis, emphysema or asthma. - Persons with an overactive thyroid gland or experiencing phaeochromocytoma (a tumor of the adrenal gland that can affect blood pressure).
    • Persons taking certain medications like Theophylline, Ropinirole or Clozapine and etc..
  2. This device is not recommended for:
    • Non-smokers
    • Pregnant or breastfeeding women
  3. You may experience the following results if you use nicotine containing e-liquid with this product. If it happens, please consult a healthcare professional and show them this leaflet if possible:
    • Feeling faint
    • Nausea
    • Dizziness
    • Headache
    • Coughing
    • Irritation of the mouth or throat
    • Stomach discomfort
    • Hiccups
    • Nasal congestion
    • Vomition
    • Chest palpitations/pain or an irregular heart rate

This device should not be used by persons under the legal smoking age.

SPECIFICATIONS

Dimensions 96.45x30.6x21.5mm
Cartridge Capacity 4ml / 2ml
Coil GTX 0.6Ω MESH COIL (20-30W) GTX 0.8Ω MESH COIL (12-20W)
Battery Capacity Built-in 1800mAh
Output Wattage 5-40W
Display 0.69" OLED Screen
Charging Type-C, 5V/2A

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Vaporesso LUXE PM40 - Vape Kit Manual

Advertisement

Need Assistance?

Do you have a question about the LUXE PM40 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents