Advertisement
programmed on your keypad on certain keys such as the Sift key.
You may save customized key settings by selecting Save Current
Settings from the Options menu.
Note
If you do not see a customization dialog box when you click on a
key, make sure that Test Mode in the Options menu is not
checked.
DOS Installation
Follow these steps to install the Port Keypad application for DOS:
1. Insert the Port Keypad setup diskette in your floppy drive.
2. Type DOSINST at the A:\ or B:\ prompt, depending on the drive
letter of your floppy drive.
3. The installation program will ask you for a destination path. The
application files will be installed in this directory. If you are
satisfied with the default path, press Enter. Otherwise, press C for
hange" and enter a new path.
4. Select a source path. This should be the path to the floppy drive.
The default is A:\. Press Enter if the default path is correct, or else
press C for hange" and enter the correct target path.
5. Select the COM port to which the Universal Remote receiver is
connected. You may choose from COM1, COM2, COM3, and
COM4. The associated base address and IRQ are listed for each
COM port.
6. Test the keypad if you wish. If you decide to proceed with the test,
the setup program will display an image of a keypad. Press the
buttons on the remote and look on the image to see the response.
Advertisement
