Targus PAUH210U User Manual page 6

6 Follow the on-screen instructions to complete the driver
installation.
You can now connect USB devices to the hub or
daisy-chain additional hubs.
Model PAUH210
The "Y" power cable that connects the model PAUH210 hub to
your computer has two USB type A connector ends, one black
and one red.
The black connector supports up- and downstream data flow
between the hub and your computer and provides power to the
hub and any device attached to the hub. The red connector only
provides power; data flow is not supported.
When the USB type A connectors are used together, the "Y"
power cable provides enough power to run any attached
device, even devices that consume large amounts of
bandwidth, eliminating the need for an AC power adapter (if
the device has one).
1 Turn on your computer (if it's off).
2 Using the supplied "Y" power cable, plug the black USB
type A connector end into a USB port on your computer.
"Y" power cable with USB type A and B connector ends
3 Plug the red USB type A connector end into another USB
port on your computer for additional power to the hub.
6