Paper Handling; Changing The Paper Type - Tally T2265 SprintPro Operator's Manual

Paper handling

Paper handling
This section describes how to set the paper type, load fanfold paper and single sheets, trans-
port paper and move the paper to the tear position.
Changing the
You can change the paper type either from an application program, by means of the paper
paper type path quick selection feature or in the Setup menu. In this section, the quick selection feature
is described; for detailed information on how to make this setting via the Setup menu, refer
to the Reference Manual on the Online CD-ROM.
On some printer models, the single sheet paper source cannot be selected since these models
are not designed for manual single sheet feeding.
Offline Tractor1
Park Load Online
1 2 3 4
Setup
Single Tractor
Online
1 2 3 4
Setup
Load paper from
Online
Single
1 2 3 4
Setup
Online Single
Load Online
1 2 3 4
Setup
14
Make sure that the printer is in offline mode; press the Online key, if necess-
ary.
Press the Park (1) key. If fanfold paper is loaded in the printer, it is fed to the
tear position. The text tear paper off appears in the display. Then press any
key. If a single sheet is loaded in the printer, it is ejected.
Use one of the marked keys to select the desired paper path, for example,
Single (2).
If you do not make a selection within 5 seconds, the menu is closed.
The printer returns to offline mode. The display alternates between the basic
menu and the menu in the following figure:
Insert a single sheet (for the procedure, see page 17, Loading single sheets).
Press the Online key to set the printer to ready status. When the printer re-
ceives data from the computer, the single sheet is automatically loaded. Press
the Load (4) key to load the single sheet before starting the printout.
Quick start-up