TallyGenicom 6300 Series Quick Start Manual

Quick Start Guide

1. Remove the Shipping
Hardware
There are 4 screws, identified by red tags, that
secure the printer base to the inside mechanism,
and tie restraints that secure the Paper Stacking
Chains. The upper 2 shipping screws have wing-
heads which tighten a bracket against the platen to
prevent it from bumping
against the hammer bank.
The lower 2 shipping
screws fasten from
underneath, near the
front of the printer
cabinet. Remove all of
these restraints, including
the brackets beneath the
wing-head screws.

4. Install the Ribbon Cartridge

Step A. Open the printer lid. Remove slack in the new ribbon by turning the knob on the ribbon cartridge as indicated by the arrow printed
next to the knob.
Ribbon Cartridge
Step B. Carefully position the ribbon between the two panels of the ribbon shield.
6300 Series
Hammer
Bank
Housing
Step C. Press down lightly on the cartridge while turning the ribbon knob as before until it seats on
first the left, (as shown), and then the right cartridge drive posts. Make sure that the ribbon does
not twist or fold over.
2. Set Up Paper Stacking Chains
Paper exits the print area through a set of passive Paper Stacking Chains
that help fold and stack printed forms uniformly. Secure two of the
chains to the wire guide and two to the rear paper guide so that the
paper can be fed between them. Make sure chains are not tangled.
Rear Paper Guide
Paper comes out between these two
3. Connect the I/O and Power Up
Secure the cable to the printer interface using the correct connectors.
Shielded I/O cables must be used on all installations
to comply with regulatory requirements.
Serial Interface Port
Parallel Interface Port
Optional LAN
interface or
Optional Twinax/Coax interface
Tractors
Ribbon Cartridge
sets of chains.
Shaft for
Tractors
On/Off Switch
& Power Plug