Adjustments - Chamberlain LiftMaster PREMIUM Series Manual

Adjustments

Without a properly installed safety reversal
system, persons (particularly small children)
could be SERIOUSLY INJURED or KILLED by a
closing garage door.
• Incorrect adjustment of garage door travel
limits will interfere with proper operation of
safety reversal system.
• After ANY adjustments are made, the safety
reversal system MUST be tested. Door
MUST reverse on contact with 1-1/2" (3.8
cm) high object (or 2x4 laid flat) on floor.
To prevent damage to vehicles, be sure fully
open door provides adequate clearance.
INTRODUCTION
Your garage door opener is designed with
electronic controls to make setup and
adjustments easy. The adjustments allow you
to program where the door will stop in the
open (UP) and close (DOWN) position. The
electronic controls sense the amount of force
required to open and close the door. The
force is adjusted automatically when you
program the travel.
NOTE: If anything interferes with the door's
upward travel it will stop. If anything interferes
with the door's downward travel, it will reverse.
To watch a short instructional video on
programming your new garage door opener
use your smartphone to read the QR Code
below:
PROGRAMMING BUTTONS
The programming buttons are located on the
left side panel of the garage door opener and
are used to program the travel.
UP (Open)
23
DOWN (Close)
PROGRAMMING BUTTONS
UP Button
Adjustment
Button
DOWN Button