Connectors - Axis 02462-001 User Manual

AXIS XFQ1656
Specifications

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
USB connector
Use the USB connector to connect external accessories. See the product's datasheet for supported accessories.
Audio connector
• Audio in – 3.5 mm input for a digital microphone, an analog mono microphone, or a line-in mono signal (left channel is
used from a stereo signal).
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
Audio input
1 Tip
Unbalanced microphone (with or without electret
power) or line
Balanced microphone (with or without phantom power)
or line, "hot" signal
Digital signal
Audio output
1 Tip
Channel 1, unbalanced line, mono
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (12 V DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Supervised input - Enables possibility to detect tampering on a digital input.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, through an event or from the device's web interface.
6-pin terminal block
2 Ring
Electret power if selected
Balanced microphone (with or without phantom
power) or line, "cold" signal
Ring power if selected
2 Ring
Channel 1, unbalanced line, mono
62
3 Sleeve
Ground
Ground
Ground
3 Sleeve
Ground