Led Indicator Lights On The Rear Of Subwoofer And Surround Speakers - Samsung HW-Q990C/XY Full Manual

LED Indicator Lights on the Rear of Subwoofer and Surround Speakers

LED
Subwoofer
Blue
Surround Speakers
Blue
Subwoofer
Red
Surround Speakers
Red
Subwoofer
Red and blue
Surround Speakers
Red and blue
NOTE
• If the main unit is powered off, the subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will turn red
after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
• The maximum transmission distance of the main unit's wireless signal is about 10 m, but may vary depending on your operating environment.
If a steel-concrete or metallic wall is between the main unit and the subwoofer, the system may not operate at all because the wireless signal
cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the subwoofer and Surround Speakers. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the subwoofer and the Surround Speakers are clear of any obstructions.
Status Description
Successfully connected
On
(normal operation)
Blinking Recovering the connection
Standby (with the
Soundbar main unit turned
off)
On
Connection failed
Blinking Malfunction
-
Check if the power cable attached to the main Soundbar
unit is connected properly or wait about 5 minutes.
If blinking persists, try manually connecting the
subwoofer and Surround Speakers. See page 11.
Check if the power cable attached to the main Soundbar
unit is connected properly.
Connect again. See the instructions for manual
connection on page 11.
See the contact information for the Samsung Service
Centre in this manual.
ENG - 12
Resolution