Table of Contents
Advertisement
Appliance settings
en
Q
Appliance settings
Y ou can change the following settings:
A p p l i a n c e s e t t i n g s
The volume of the end signal.
■
The volume of the button signal.
■
You will need to activate the setting
mode in order to change these settings.
1/2/3/...
positions on the
programme selector
Activate setting mode:
Set the programme selector to
1.
position 1. The appliance is switched
on.
Touch and hold the Start/Reload A
2.
button and, at the same time, turn
the programme selector clockwise to
position 2. Release the Start/Reload
A button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume
Use the Finished in ñ button to
change the following settings at the
corresponding programme selector
positions:
2: The volume of the end signal.
■
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
40
Exiting setting mode
You can now end the process and set
the programme selector to the Off
position. The settings are saved.
H
Sensors
U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.
Advertisement
Table of Contents
