ViewSonic LS610WHE User Manual page 43

Menu Option
Auto Power On
Smart Energy
Standby Settings
Signal
Selecting HDMI allows the projector to turn on automatically
once the HDMI signal is fed through the HDMI cable.
CEC
This projector supports CEC (Consumer Electronics Control)
function for synchronized power on/off operation via HDMI
connection. That is, if a device that also supports CEC function
is connected to the HDMI input of the projector, when the
projector's power is turned off, the power of the connected
device will also be turned off automatically. When the power
of the connected device is turned on, the projector's power
will be turned on automatically.
NOTE:
• In order for the CEC function to work properly, make sure
that the device is correctly connected to the HDMI input
of the projector via an HDMI cable, and its CEC function is
turned on.
• Depending on the connected device, the CEC function may
not work.
Direct Power On
Allows the projector to turn on automatically once power is fed
through the power cord.
Auto Power Off
Allows the projector to turn off automatically after a set
period of time once no input source is detected to prevent
unnecessary waste of light source life.
Sleep Timer
Allows the projector to turn off automatically after a set period
of time to prevent unnecessary waste of light source life.
Power Saving
Lowers power consumption if no input source is detected.
When Enable is selected, the projector will change to SuperEco
mode after no signal is detected for five (5) minutes. This will
also help prevent any unnecessary waste of light source life.
The functions below are available in standby mode (plugged in,
but not turned on).
Audio Pass Through
When selecting On, the projector outputs an audio signal when
the Audio In and Audio Out sockets are correctly connected to
a proper device.
43
Description