ATOMSTACK A6 PRO User Manual page 12

8. Power-off Resume Engraving
8.2.2 Select the engraving file.
8.2.3 Use the touch screen controller to move the laser to the desired engraving position, as shown in Figure 1.
8.2.4 Click "Auto Focus", as shown in Figure 2.
8.2.5 Click "Set as Bottom-Left Corner" to set the current position as the initial position, as shown in Figure 3.
8.2.6 Click "Start". After parsing the file, the machine will automatically start the engraving process, as shown in Figure 4.
8.2.7 In case of a power outage during the engraving process, after powering on, the machine will prompt "Unfinished job present".
Click "Confirm" and the machine will parse the coordinates and continue engraving the unfinished part.
Engraver 12345
4
2
3
10
1