Table of Contents
Advertisement
Transport with eye
bolt in drive shaft
(only permissible with
sizes 110 and 145)
Transport with eye bolt in
housing (only possible for
sizes 175, 210 and 280)
6.1.2 Transport with lifting devices
For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt in the drive shaft or in the housing. Alternatively, it can also be transported with
lifting strap. When selecting the means of transport, consider the permissible total
weight.
Only use the lifting strap if you are unable to achieve the required installation
position with transport using the eye bolts.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶
For all female threads, use a stud end from the same system of units and of the
correct size.
▶
To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is indicated in the installation drawing.
▶
Make sure that the eye bolt can bear the total weight of the axial piston
unit plus 20%.
You can lift the axial piston unit as shown in Fig. 5 with the eye bolt screwed into the
drive shaft.
Fig. 5: Mounting the eye bolt in the drive shaft
▶
For all female threads, use a stud end from the same system of units and of the
correct size.
▶
Screw an eye bolt fully into the female thread in the housing.
▶
Make sure that each eye bolt can bear the total weight of the axial piston unit
plus approx. 20%.
You can hoist the axial piston unit as shown in Fig. 6 with the eye bolts screwed into
the housing.
RE 92511-01-B/2019-10-09, A15V(L)O Series 11, Bosch Rexroth AG
Transport and storage
23/64
Advertisement
Table of Contents
