Transport With Lifting Devices - Bosch rexroth A4VSH Series Instruction Manual

24/64 A4VSH series 1x and 30 | Transport and storage
Transporting with eye bolt
Transport with lifting strap
Bosch Rexroth AG, RE 92110-01-B/2022-03-22
6�1�2 Transport with lifting devices
For transporting, the axial piston unit can be connected to a lifting device via an
eye bolt or a lifting strap.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶ For all female threads, use a stud end from the same system of units and of the
correct size.
▶ To do this, screw an eye bolt completely into the female thread on the drive
shaft. The thread size is indicated in the installation drawing.
▶ Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20%.
You can lift the axial piston unit as shown in Fig. 4 with the eye bolt screwed into
the drive shaft.
Fig� 4: Mounting the eye bolt
WARNING! Danger due to suspended loads!
During transport with lifting strap, the axial piston unit can topple out of the lifting
strap and cause injury.
▶ Use the widest possible lifting strap.
▶ Make sure that the axial piston unit is securely fixed with the lifting strap.
▶ Only guide the axial piston unit by hand for fine positioning and to avoid
swinging.
▶ Never step or grip under suspended loads.
▶ Place the lifting strap around the axial piston unit in such a way that it does not
pass over assembled parts (e.g. valves, piping) and that the axial piston unit is
not suspended from assembled parts (see Fig. 5).