Transport And Storage; Transporting The Axial Piston Unit; Transporting With A Lifting Device - Bosch REXROTH A4 Series Instruction Manual

Axial piston variable pump with hs5e pilot control valve
Table of Contents

Advertisement

36/104

Transport and storage

Dimensions and
weights
Transport with eye bolt in
the drive shaft
Bosch Rexroth AG, A4... with HS5E pilot control valve/Series 3x, RE 92076-01-B/10.2017
6 Transport and storage
Always observe the required ambient conditions for transport and storage, see
Chapter 6.2 "Storing the axial piston unit" on page 38.
Information on unpacking can be found in chapter 7.1 "Unpacking" on page 40.

6.1 Transporting the axial piston unit

The following transportation options are available depending on the weight and
duration of transport:
• Transporting with a lifting device (eye bolt or lifting strap)
Table 8: Dimensions and weights (without through drive) of A4VSO
Size
40
Ground
kg
55
Width
mm
Dimensions vary by equipment. The values applicable for your axial piston
unit can be found in the installation drawing (request if necessary).
Height
mm
Depth
mm
Weight may vary by equipment.

6.1.1 Transporting with a lifting device

For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt in the drive shaft or in the housing. Alternatively, it can also be transported with
a lifting strap.
Only use the lifting strap if you are unable to achieve the required installation
position with transport using the eye bolts.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
For all female threads, use a stud end from the same system of units and of the
correct size.
To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is stated in the installation drawing.
Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20%.
You can hoist the axial piston unit as shown in Fig. 9 with the eye bolt screwed into
the drive shaft.
71
125
180
250
68
100
115
197
355
500
750
1000
220
335
475
620

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rexroth a4vsoRexroth a4vsgRexroth a4csgRexroth a4vbo

Table of Contents