Table of Contents
Advertisement
Registering magic remote
How to register the magic remote
To use the Magic Remote, first pair it with your TV.
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
the remote control.
* If the TV fails to register the Magic Remote, try again after turning the
TV off and back on.
How to deregister the magic remote
Press and hold the
(BACK) and
time for five seconds, to unpair the Magic Remote with your TV.
* Pressing and holding the
button will let you cancel and re-
register Magic Remote at once.
How to use magic remote
• Shake the Magic Remote slightly to the right and left or press
(HOME),
(INPUT),
buttons to make the pointer appear on
the screen.
(In some TV models, the pointer will appear when you turn the
Wheel (OK) button.)
• If the pointer has not been used for a certain period of time or
Magic Remote is placed on a flat surface, then the pointer will
disappear.
• If the pointer is not responding smoothly, you can reset the pointer
by moving it to the edge of the screen.
• The Magic Remote depletes batteries faster than a normal remote
due to the additional features.
Precautions to take when using the
magic remote
• Use the remote control within the specified range (within 10 m).
You may experience communication failures when using the device
outside the coverage area or if there are obstacles within the
coverage area.
• You may experience communication failures depending on the
accessories.
Devices such as a microwave oven and wireless LAN operate in the
same frequency band (2.4 GHz) as the Magic Remote. This may
cause communication failures.
• The Magic Remote may not work properly if a wireless router (AP)
is within 1 meter of the TV.
Your wireless router should be more than 1 m away from the TV.
• Do not disassemble or heat the battery.
• Do not drop the battery. Avoid extreme shocks to the battery.
• Inserting the battery in the wrong way may result in explosion.
Licenses
Supported licenses may differ by model. For more information about
licenses, visit www.lg.com.
Wheel (OK) on
Open source software
(HOME) buttons at the same
notice information
To obtain the source code under GPL, LGPL, MPL, and other open
source licenses, that is contained in this product, please visit http://
opensource.lge.com .
In addition to the source code, all referred license terms, warranty
disclaimers and copyright notices are available for download.
LG Electronics will also provide open source code to you on CD-ROM
for a charge covering the cost of performing such distribution (such
as the cost of media, shipping, and handling) upon email request to
opensource@lge.com. This offer is valid for three (3) years from the date
on which you purchased the product.
Troubleshooting
Cannot control the TV with the remote control.
• Check the remote control sensor on the product and try again.
• Check if there is any obstacle between the product and the remote
• Check if the batteries are still working and properly installed (
No image display and no sound is produced.
• Check if the product is turned on.
• Check if the power cord is connected to a wall outlet.
• Check if there is a problem in the wall outlet by connecting other
The TV turns off suddenly.
• Check the power control settings. The power supply may be
• Check if the Automatic Standby(Depending on model) / Sleep
• If there is no signal while the TV is on, the TV will turn off
When connecting to the PC (HDMI), 'No signal' or 'Invalid Format' is
displayed.
• Turn the TV off/on using the remote control.
• Reconnect the HDMI cable.
• Restart the PC with the TV on.
control.
to ,
to ).
products.
interrupted.
Timer / Timer Power Off is activated in the Timers settings.
automatically after 15 minutes of inactivity.
15
Advertisement
Table of Contents
